Check for proper operation of pump
Check for leaks on suction and discharge piping, seals, packing glands, etc; make minor adjustments as required
Check pump and motor operation for excessive vibration, noise and overheating
Check alignment of pump and motor, adjust as necessary
Lubricate pump and motor
Inspect hydraulic lift post(s) for wear or leaks
Inspect, clean and tighten valves
Inspect and clean motor contactors
Inspect and test control relays and check wiring terminals
Clean pump unit.
Clean surrounding area, record results and findings and report any needed repairs or operational adjustments.

Obtain and review manufacturer's instructions.  Follow manufacturer’s instructions or procedures if different to these instructions or procedures.
Review Standard Operating Procedure for Controlling Hazardous Energy Sources.
De-energize, tag, and lock out circuit.

Standard and Phillips head screw drivers-various sizes; Pliers-vise grip (2), slipjoint, needlenose, diagonal; cutting pliers, side cutters; Ball peen hammer; Hack saw and spare blades; 3/8' drive socket set and ratchet; Small set of Allen wrenches; Assorted center punches, drift punches, and steel chisel; 12' measuring tape; Crescent wrenches 4" to 8";  Open and box end wrenches ¼" to ¾"; File; Pipe wrenches to 14"; Small level and square; Pocket knife; Flashlights; Grease guns and oilers; Wire brush; Extension cord and inspection lights; Various cleaning tools - brushes, scrapers, etc; Emery cloth.
Grease gun, grease, oil.
Safety goggles.
Gloves.