Remove all hold-open devices such as fusible links except approved electro-magnetic hold open devices. 
Check hang and swing for close fit.  Doors must latch on normal closing cycle and have a neat fit. 
Remove any obstructions that retard full swing or movement of door.
Test operation of panic hardware.  Inspect door coordinates on pairs.
Check operation of any special devices such as smoke detectors or magnetic door releases.
Inspect door for damage
Clean surrounding area, record results and findings and report any needed repairs or operational adjustments.

Obtain and review manufacturer's instructions.  Follow manufacturer’s instructions or procedures if different to these instructions or procedures.
The work required by this procedure may cause the activation of an alarm and/or a supervisory signal.  The control center or fire department that will receive the alarm and/or signal must be notified prior to start of work.

Standard and Phillips head screw drivers-various sizes; Pliers-vise grip (2), slipjoint, needlenose, diagonal; cutting pliers, side cutters; Ball peen hammer; Hack saw and spare blades; 3/8' drive socket set and ratchet; Small set of Allen wrenches; Assorted center punches, drift punches, and steel chisel; 12' measuring tape; Crescent wrenches 4" to 8";  Open and box end wrenches ¼" to ¾"; File; Pipe wrenches to 14"; Small level and square; Pocket knife; Flashlights; Grease guns and oilers; Wire brush; Extension cord and inspection lights; Various cleaning tools - brushes, scrapers, etc; Emery cloth.
Gloves.